Antislip Kitchens

Antislip Vinyl Backed Products

Features

  • Remains antislip even when soiled or wet.
  • Completely sealed against the intrusion of extraneous materials.
  • Good chemical resistance.
  • Easy to clean and disinfect.
  • Long effective life.
  • Simple to install.
  • Colours available: charcoal, other colours available upon request.
  • Grades: Fine, Industrial

Sizes available & how to specify

Width x Length
Metric Imperial
600mm x 750mm 24" x 30"
600mm x 900mm 24" x 36"
600mm x 1200mm 24" x 48"
200mm x 600mm 8" x 24"
200mm x 750mm 8" x 30"
200mm x 900mm 8" x 36"
Slipfixa: 100mm x 450mm 4" x 18'
For non-standard sizes, please contact us.

 

To specify:
Product name: Safemate Antislip Vinyl Products
Size: 600mm x 750mm (24" x 30")
Colour: Charcoal
Grade: Fine
Backing: Vinyl
Installed Over: Ceramic Tile, Concrete, and Timber surfaces

 

Installation instructions

  1. Ensure that the floor surface is clean, dry and free of paint. If the room temperature is below 20 degrees Celsius, remove the segments from the pack and warm them to facilitate installation.
  2. Mark out the area where the segments are to be laid.
  3. Use the two part flexible waterproof exterior tile adhesive. Mix to manufacturer's instruction. Available ex Safemate Antislip.
  4. Use a 3mm (1/8") notch trowel, spread adhesive over marked out area of up to 2 square meters (22 sq ft.). Place the segment of Vinyl Backed Floor Products on the adhesive and pat down gently.
  5. Allow 6 to 8 hours drying time before walking on surface.
  6. When adhesive dries, cut along the segment edge with a sharp knife and peel off the excess adhesive.

Cleaning instructions

To clean Antislip Vinyl Backed Products, use a rotary brush cleaner, a hot hose or a stiff brush. Squeegee excess water off each section onto surrounding floor, where the excess water can be picked up with a mop or a wet or dry vacuum cleaner.

Other Antislip Products